Komptec GmbH. KT-90A User Manual
Page 18 of 52
v1.0a; 8 May 2016
3.2.5.
Notes on special types of hazard
Electric power
In case of faults in the electrical power supply, the system must be switched off immedi-
ately!
Work on electrical systems or equipment must be carried out by a qualified electrician or
by instructed persons under the direction and supervision of a qualified electrician.
The electrical equipment must be regularly inspected / checked. Defects such as loose
connections or scorched cables must be rectified immediately.
Pneumatics
All lines, hoses and fittings must be checked regularly for leaks and externally visible
damage! Damage must be eliminated immediately! Splashed oil may cause injury and
fire.
Insure that the system and any hoses are depressurized before starting any repair work!
Compressed air lines must be professionally installed and mounted! Do not interchange
connections! Fittings, length and quality of the hoses must comply with the requirements.
Hazard statements for dealing with the filter and pressure vessels
Never remove reservoir cap or pipe connection parts under pressure.
The KT-90A has a container (filter) for dynamic load. This pressure vessel may be oper-
ated under varying operating pressure. The pressure may vary between the atmospheric
and the maximum operating pressure.
We recommend replacing aluminum containers at least every 15 years.
This measure should be observed to ensure your own safety and that of your employees
and customers!
Check your pressure vessels regularly inside and outside for damage from corrosion.
Residual Risk Zones
DANGER: In some compressor zones there remain residual risks that were not possible
to eliminate at the design stage or for which safety guards could not be provided without
compromising the functionality of the compressor. To prevent accidents all operators
must be aware of the residual risks on this compressor.
There is a danger of polluting the intake air due to the possibility of mixing exhaust fumes
or lubricating oil vapors with the compressed air being produced.
Electrical danger. Install electrical connections to local codes and do not use in wet lo-
cations