Komptec GmbH. KT-90A User Manual
Page 23 of 52
v1.0a; 8 May 2016
6.
Transport and Installation
6.1.
Transport
To avoid damage or serious injury during transportation of the compressor, the following
points must be observed:
•
WARNING: Manual lifting of the compressor requires at least two workers and in any
case no individual worker should lift more than 30kg (66 lbs).
•
Transport work may only be carried out in compliance with the safety instructions.
•
Also read the chapter "General safety instructions"
6.1.1.
Dimensions and Weight
Dimensions
Length
650 mm (25.6”)
Width
300 mm (11.8”)
Height
400 mm (15.7”)
Weight with Electric Motor
35 kg (77.0 lbs)
Weight with Gas Motor
35 kg (77.0 lbs)
6.1.2.
Transport to the Site
The compressor is transported to its destination and assembled on site. If required, the
compressor is preserved and packed.
Transport damage must be reported immediately.
For transportation, if necessary, appropriate lifting tools are to be used.
6.2.
Installation
To avoid damage or serious injury when installing the compressor, the following
points must be observed:
−
Manual lifting of the compressor requires at least two workers and in any case no indi-
vidual worker should lift more than 30 Kg (maximum of 50 lbs in the US)
−
The preparation work - assembly and installation of the compressor - may only be carried
out by qualified staff in compliance with the safety.
−
Before starting the installation work, the compressor must be checked for transport dam-
age.
−
Also read the chapter "General safety instructions".
6.2.1.
Conditions for Set-up
The base plate of the compressor is equipped with anti-vibration pads. A foundation or
special mounting is not required.
i
i