Instruction manual SMV 10 600B – 60 1500B Publ. no. 6196.082 1117, Version 02
55
Service and maintenance
Removal of the inside driving wheel
• Remove the outer driving wheel.
• Remove the spacer (6).
• Support the weight of the inner wheel (7) using the forks of the
support truck.
• Lean the wheel (7) against the wheel holder on the support
truck (1) and fixate it with a chain (8).
• Carefully reverse the support truck away and unload the outer
wheel (7).
Fitting of the inside driving wheel
• Load the inner driving wheel (7) on the support truck and fit it
to the holder.
• Clean the contact surfaces.
• Carefully manoeuvre the support truck into place and position
the inner wheel (7) over the driving shaft and hub.
• Remove the fixing device from the wheel holder (1) and the
inner wheel (7) and straighten up the wheel (7).
• Lower the fork on the support truck until the inner wheel (7)
rests on the hub.
• Carefully reverse the support truck away.
• Refit the spacer (6).
Fitting of the outside driving wheel
• Load the outer wheel (5) on the support truck and fit it to the
holder.
• Carefully manoeuvre the support truck into place and position
the outside wheel (5) over the hub.
• Remove the fixing device from the wheel holder (1) and the
outer wheel (5) and straighten up the wheel (5).
• Fit the clamps (3) and the nuts (2), placed diagonally against
each other in order to keep the wheel in place.
• Carefully reverse the support truck away.
• Fit the remaining clamps (3) and nuts (2) and cross-wise tighten
the wheel nuts applying the torque stated in section
"Retightening of bolt joints, torque" on page 57.
• Fill the tyres in accordance with the tyre manufacturers
recommendations.
