458122/B
15
connecting the cNODE battery charger to the mains. The battery will be charged within
1 hour. The LED indicator will stay green when fully charged.
The transponder is ready for use.
Turning on the transponder
The transponder is designed for operation in water only. The transponder may be
operated in air for test purposes over a short period of time.
Prerequisites
The transponder must be charged before use.
Procedure
1
Grease the connector with Molykote 44 Medium or equivalent grease.
Lubricating SEACON connectors, page 26
2
Connect the on/off plug to the end cap connector.
3
Tighten the locking sleeve to the end cap connector.
Result
A buzz can be heard within 25 seconds as a confirmation that the transponder is activated.
Further requirements
It is recommended to test the transponder with the Test and Configuration unit (TTC) to
make sure it is working properly before operation.
Summary of Contents for cNODE MiniS LF
