48
922-20207001/1.0
Measuring angles
You can use the protractor to measure the angle between two lines, then place the
resulting overlay in the sonar view.
Context
The protractor tool measures the angle between a baseline and a second line that
intersects the baseline.
Procedure
1
Click the
Protractor
button.
This button is located on the tool bar.
2
In the sonar view, click the point where you want to start the baseline.
3
Click the point where you want to end the baseline.
The second line will appear.
4
Lock one end of the second line to the baseline.
a
Choose where you want the second line to intersect the baseline by moving the
mouse along the length of the baseline.
b
When ready, click the left mouse button.
5
Choose where you want the second line to end.
a
Move the mouse to any point on either side of the baseline to adjust both the
length and angle of the second line.
b
Click the left mouse button to place the overlay.
Tip
To remove this overlay, click the
Wiper
button, then click the overlay.
Related topics
Defining an area
You can use the string measure tool to define an area. The size and perimeter of the
area will be calculated for you.
Context
Defines and measures perimeters and areas. Allows you to place an area overlay on
the sonar view.
Flexview Reference Manual
Summary of Contents for Flexview
