50
922-20207011/1.0
c
Remove the additional rubber insulation wrapped around each Ethernet pair.
To avoid severing the wires, make a small incision with the side cutters, then
peel off the rest by hand.
d
Using the side cutters, cut each Ethernet pair to a different length so that there will
be a 1/4″ spacing between each wire splice.
This spacing is necessary so that the wire splices are not all bunched together
(causing a bulge in the cable).
Flexview Installation Manual
Summary of Contents for Flexview
