5. The Tri Display (Fuel Computer Modes)
Figure 3.2. A fuel computer
display.
Note. Metric units are shown as
default, but others may be
selected via the configuration
menu.
Below is the list of parameters that can be displayed in the fuel computer window in alphabetical
order:
Distance Remaining:
Calculated if Fuel Tank Capacity is set and Fuel Rate, Vehicle Speed
and Fuel Level are available [Distance]
Fuel Level:
If available [Volume]
Fuel Rate:
If available [Volume/Hour]
Fuel Remaining:
Calculated if Fuel Tank Capacity is set and Fuel Level is availiable [Volume]
Instantaneous Fuel Economy:
Calculated if Vehicle Speed and Fuel Rate are available
[Distance/Volume]
Total Engine Hours:
If available [Hours]
Total Vehicle Distance:
If available [Distance]
page 9
The lower left display window provides access to the fuel computer
data and also shows fuel tank level. Upon pressing key 1 the fuel
computer is highlighted, when highlighted various data can be
displayed by repeat pressing of key 1. When first selected a small
icon will also appear in the centre of the screen with the text “Hold
Reset”. Holding key 1 at this time will perform a Trip Reset. After 2
seconds of no key presses the fuel computer will go back to normal
and the icon will disappear.
Data Available is similar to an automotive in-car fuel computer.