442700/A
285
• Relevant tools are required to remove marine growth and to apply anti-fouling paint. All
tools must be provided by the shipyard.
• Anti-fouling paint must be provided by the shipyard.
Note
Do not
direct high-pressure water or sandblasting spray towards the transducer. This
will damage the transducer beyond repair.
Two persons are needed to do the task.
• One person must stay in the sonar room to operate the hull unit.
• One person must stay in the dry dock, under the hull, to make sure that the transducer is
not lowered too far down.
Proper oral communication must exist between the sonar room and the dry dock personnel.
Procedure
1
Make sure that all power to the hull unit is disconnected.
2
Cover the opening in the installation trunk with a solid wooden or steel plate to protect
the transducer.
3
Do a close visual inspection of the blister and the hull plating close to the installation
trunk.
a
Remove marine growth.
b
Apply anti-fouling paint to protect the hull plating and prevent marine growth.
c
Make sure that all surfaces are protected with a high quality coating.
4
Access the inside of the installation trunk.
Accessing the inside of the installation trunk, page 297
5
Do a close visual inspection of the inside of the installation trunk.
a
Remove marine growth.
Note
Do not
direct high-pressure water or sandblasting spray towards the transducer.
This will damage the transducer beyond repair.
b
Apply anti-fouling paint.
c
Make sure that the inside of the installation trunk is properly protected with
coating.
6
Use the hand crank to hoist the transducer.
Summary of Contents for Simrad CS90
