442700/A
257
5
Select
Transceiver
to open the page.
The
Transceiver
page provides a graphic presentation of the transceiver boards. The
visual presentation reflects the physical location of the boards in the Transceiver
Unit. Only static information is provided. The
Board Information
parameters offer
key information about the supply power to the selected transceiver board, as well as
the environmental conditions.
To select a transceiver board, click the "button". Relevant information about the
selected transceiver board is provided under
Board Information
.
To disable or enable a transceiver board, right-click the "button" and use the short-cut
menu.
Each button provides a small colour coded indicator.
•
No indicator
: Status is OK. No actions are necessary.
•
Yellow
: This is a warning. A closer investigation is recommended.
•
Red
: This is an alarm. A closer investigation is required.
•
Blue
: A device monitored by the diagnostic system is disabled.
•
Grey
: No information is available.
6
Make sure that all the transceiver boards are fully functional.
7
Finish the test.
a
Close the
Diagnostics
dialog box.
b
Set
Tx Power
to
Off
.
c
Hoist the transducer back up to its upper position.
Related topics
Maintenance procedures, page 186
Testing the noise conditions and the sonar functionality, page 255
Transceiver page, page 542
Checking the transducer by means of the Diagnostics
functionality
The purpose of the
Diagnostics
dialog box is to allow on-line testing and verification of the
hardware components in the CS90 system. Use the
Transducer
page to do a reception test to
check the individual transducer elements. Any errors are then easily detected.
Prerequisites
Neither tools nor instruments are required.
Summary of Contents for Simrad CS90
