922-00047001/1.1
47
Related topics
Placing reference cursors
You can place one or two reference cursors as overlays on the sonar view. When you place
two cursors, an additional overlay will appear with information about the cursors.
Context
The Reference Cursor buttons are used to mark points of interest and
to determine the range and bearing of these points (relative to the
Sonar Head).
These buttons are located on the top bar.
Procedure
1
Click the
Reference Cursor 1
button.
2
Move the mouse to where you want to place the cursor.
3
Click the left mouse button to place the cursor as an overlay in the sonar view.
The range and bearing of the cursor’s position — relative to the Sonar Head — is
shown in the bottom-left corner of the view.
4
Click the
Reference Cursor 2
button.
5
Move the mouse to where you want to place the cursor.
6
Click the left mouse button to place the cursor as an overlay in the sonar view.
The range and bearing of the cursor’s position — relative to the Sonar Head — is
shown in the bottom-left corner of the view. “Delta” shows the range and bearing
from cursor 1 to cursor 2.
Tip
To remove this overlay, click the
Wiper
button, then click the overlay. You can also click
the
Reference Cursor
button again to remove the cursor.
Related topics
Summary of Contents for Simrad FM90i
Page 1: ...REFERENCE MANUAL Simrad FM90i software kongsberg com simrad ...
Page 2: ......
Page 8: ...6 922 00047001 1 1 Simrad FM90i ...
Page 104: ... 2021 Kongsberg Maritime ...
