182
442704/A
a
Select an output type from the list.
b
Select the communication port you want to use.
c
Select which marker type to export.
d
Select
Add
to save the output format.
e
Select
Apply
to save your choices.
4
If you want to check the communication parameters, select
Inspect Port
.
Note
You cannot make any changes here. To change the communication parameters, use
the
I/O Setup
page. The
I/O Setup
page is located in the
Installation
and
Output
dialog
boxes.
5
If you want to check the data flow on the selected port, select
Monitor
.
In order to see this data traffic, your ST90 system must be active and transmitting
information to the peripheral system.
The
Port Monitor
dialog box provides one text box for incoming messages (
Rx Data
),
and one for outgoing messages (
Tx Data
). Use these boxes and your knowledge of the
data communication to investigate the datagrams. The
Port Monitor
dialog box is a
tool for debugging purposes. It is neither required nor intended for normal operation of
the ST90 system.
6
At the bottom of the
Output
dialog box, select
OK
to save the chosen parameters and
close it.
Related topics
Operating procedures, page 79
Exporting sensor data, marker positions and technical information, page 181
Marker Output page, page 523
Simrad ST90 Reference Manual
Summary of Contents for Simrad ST90
