16
Accessories for KDC 8000:
Transport wheels and drawbar
Wheels and drawbar for transportation on rough
ground after a tractor. Use only over short distanc-
es. All local traffic regulations must be observed -
be especially aware not drive too fast, to avoid any
accidents!
Cleaning brushes for the outer screens
When using outer screens with small or oblong
holes for separation of kernel sizes, the outer
screen can be clogged with impurities or kernels
blocking the perforation.
To clean the screens, it is advised to install clean-
ing brushes.
Cleaning brushes are
installed in the top, on the
left side of the cleaner
Rain cover for gear motor
The rain cover will protect the gearmotor against
impact from the weather when installed outdoor.
Kongskilde offers two types; one for 50Hz motors,
and one for 60Hz motors.
Rain cover 50Hz
Rain cover 60Hz
Flexible connection
As a link between a pipe system and the cleaners
inlet funnel, a flexible connection is available. This
will allow stepless height adjustment of the cleaner
without dismantling of any pipes. The connection
can be adjusted in height, and is equipped with a
neoprene sock, to avoid penetration of rain.
Test screens
A range of hand held screens with different perfora-
tions are available from Kongskilde. These can be
used to do preliminary cleaning tests, which will
give a good guideline for deciding screen selection.
Screens
Furthermore, inner and outer screens are offered
with varying hole diameters, please contact Kong-
skilde for further information. See also section
"Screen sizes".
Piping for conveying of impurities
A wide range of OK 200 piping components and
cyclones are available for conveying the impurities
from the cleaner to disposal into location for storage
of impurities.
Summary of Contents for KDC 8000
Page 1: ...KDC 8000 Combi cleaner Manual Brugsanvisning...
Page 35: ...35...
