5
The operators panel can be moved onto other locations
if desired. This is done as follows:
1 - The operator´s panel is unhooked and laid onto the
blowers motor. Put a cloth or similar under the panel to
avoid scratches on the display.
2 - The 8 pcs. M6 screws on the back side of the
panel´s bracket are removed.
3 - The panel is turned, the two wires disconnected,
and the panel put aside.
4 - The blower cover to the left of the operators panel is
removed (attached with two M6 screws), and the cable
tie is cut.
5 - The cable relief in the panel´s bracket is loosened,
the wires are pulled out of the bracket and out of both
holes in the blower´s end plate, and guided down the
left side of the blower.
6 - Both wires are led through an M25 cable relief (not
included), that must be fitted at the front or back of the
blowers base frame, taking into account the operator
panel's new location.
