24
Replacing the frequency converter
If the frequency converter has been replaced, proceed as follows:
•
login as Admin
•
press the Kongskilde logo in the upper right corner for 10 sec
•
The Kongskilde logo changes to LOAD MOTOR DATA and flashes
•
press the flashing LOAD MOTOR DATA
•
on the new page press: Load parameters to drive
•
when the blue bar is at 100%, press Return
The software is now downloaded to the frequency converter.
In the event that it is not possible to load the new data, the frequency con-
verter is not set up to communicate via the Profinet connection.