17
Adjustment and use of the Vibro Master 3000
The Vibro Master 3000 can be equipped with 4 different types of tines. See table
below for recommended settings and use.
Type of tine
Working depth Working
speed
Tine distance
Conditions
Vibro S
(32x10,5 mm)
4 – 10 cm
8 – 12 km/h
10 cm
Seedbed
Vibro Super Q
(32x12,4 mm)
4 – 10 cm
8 – 12 km/h
8 cm
Seedbed
Vibro Super S
(45x11 mm)
4 – 12 cm
8 – 12 km/h
10 cm
Seedbed
VTM*)
(50x10,8 mm)
4 – 12 cm
8 – 12 km/h
15 cm
Seedbed with
some residues
*) As shares for VTM can be used 2 ½” goose foot (101000551) and 4“ sweep
(101000552) for shallow tillage.
Local conditions such as soil type, weather conditions, stones, amount of residues
etc. must always be taken into account when setting the cultivator.
Adjustment of the working depth (cultivator)
The cultivator must be lifted for adjusting the working depth.
The working depth is set by means of the wheel spindles on each of the 4 rubber
wheels. An indicator is showing the position of the spindle.
The depth wheels on the centre section must be set deeper than the depth wheels on
the wings, as they sometimes are running in the tracks from the tractor. As a general
rule can be used :
Depth wheels on the centre section must be set 1 scale-point deeper than the
wings.
After adjustment to the correct depth remember to position the handle in
the storage clip, to prevent the handles from turning during work.
Position for VTM tines
Position for S/SQ/SS - tines
