4 - OPERATING INSTRUCTIONS
Shortening the PTO shaft
To shorten the PTO shaft proceed as follows.
1. Fasten the PTO shaft half parts to the PTO (on the
tractor) and the PIC (on the implement). The PTO
shaft half parts must be at the same horizontal level,
opposite each other at the shortest distance from the
tractor.
2. Make sure that a minimum overlap of
200 mm
(
7.87 in
) exists.
3. Check that the PTO shaft does not bottom out at one
end. Keep the shaft ends parallel to each other and
mark the minimum distance of
40 mm
(
1.6 in
). Only
cut enough PTO shaft off to achieve this minimum free
shaft length. This will maintain the maximum amount
of PTO shaft overlap.
4. Shorten all four tubes equally.
5. Round off the ends of the profile tubes and remove the
burrs carefully.
6. Remove the metal shavings.
NOTICE:
To avoid big friction forces, grease the tube
carefully before you reassemble the tube. Use
NLGI 2
.
NOTE:
If you shorten the PTO shaft, then you must check
the minimum overlap and the minimum distance again if
you operate the implement with a different tractor.
ZEIL18HT00013AA
2
4-8
Summary of Contents for Z 665 H
