3
Initial Steps . . .
3-14
Di5510/Di7210
Place Z-folded Originals in the EDH
Place up to 100 originals (80 g/m²) with a Z-fold into the EDH.
1
Enable “Z-folded original”.
For more information, see page 4-83.
2
Insert the originals face-up into the
EDH.
3
Make sure not to exceed the
maximum paper filling level. The
paper stack must not be higher than
the red mark of the indicator.
4
Align the originals to the back side
of the EDH.
5
Push the originals flush up against the feed chamber of the EDH.
6
Slide the document guide plates to fit the size of the originals.
Note the following important information!
• Original sizes:
A3, B4, F4, A4R, A4, B5R, B5, A5, A5R, B6R,
11"×17", 8.5"×14", 8"×11"
• Original types:
standard papers (50 to 130 g/m²)
• Capacity
of the EDH:
max. 100 originals (80 g/m²)
Summary of Contents for Di5510
