Settings in Key Operator Mode
7
Di5510/Di7210
7-49
7.13
(12) Energy Saver Setting
Set the amount of time that should elapse after the last button has been
pressed before one of the energy saving modes is triggered.
1
Call up key operator mode.
The key operator mode menu is displayed.
2
Press the down arrow key on the lower edge of the touch screen.
The second page of the key operator mode menu is displayed.
3
In the key operator mode menu press the [12]
Energy saving setting
key.
The screen for setting the energy saver functions appears.
4
On the left side of the touch screen select the idle time for auto low
power mode.
5
On the right side of the touch screen select the idle time for auto shut
off mode.
6
Confirm your input by pressing [OK].
The key operator mode menu is displayed again.
Set reasonable periods!
The period for the energy saving function must not exceed the period
for automatic shut off. If the same period is set for the two functions,
the automatic shut off will be enabled instead of the energy saving
function.
Summary of Contents for Di5510
