Ch.3 Setup
< 112 >
DRYPRO Vstage MODEL 793 Installation Manual Ver.1.00 2004.11
Item
Default
Descriptions
LUT SELECT
CH01~16 : 1
Sets the LUT number to be used.
Settings may be made within a range of "1" ~ "7."
For details of making LUT value settings, refer to "LUT Settings."
DENSITY
CH01~16 : 0
Sets the image density.
Lower settings (-) produce lighter density, higher settings (+) darker
density.
Settings may be made within a range of "-7" ~ "+7."
CONTRAST
CH01~16 : 0
Sets the image contrast.
Lower settings (-) produce darker contrast, higher settings (+)
brighter contrast.
Settings may be made within a range of "-7" ~ "+7."
SMOOTHING
CH01~16 : 2
Sets the image smoothing type.
The higher the set value, the smoother the type.
(Values that are too high will produce blurring.)
Selection of a value of "7" will result in printing with a setting of
[Integral Multiple Ratio] (Print condition setting).
Settings may be made within a range of "0" ~ "7".
DENSITY MAX
CH1, CH2 : 300
Sets the maximum image density.
CH03 : 400
Settings may be made within a range of "150" ~ "460."
CH04~16 : 300
DENSITY MIN
CH01~16 : 20
Sets the minimum image density.
Settings may be made within a range of "10" ~ "30."
ILLUMINATION
CH01~16 : 2000
Sets the light table brilliance.
Settings may be made within a range of "0" ~ "38000."
Since the illumination level is usually sent by the diagnostic device,
changes to this setting are not necessary.
AMBIENT LIGHT
CH01~16 : 10
Sets the ambient light.
Settings may be made within a range of "0" ~ "38000."
Since the illumination level is usually sent by the diagnostic device,
changes to this setting are not necessary.
FLIP
CH01~16 : OFF
Sets image flip.
"ON"
: The image is printed flipped.
"OFF"
: The image is printed without being flipped.
SORTER BIN
CH01~16 : 1
Sets the destination bin number for printed film.
Settings may be made within a range of "1" ~ "6."
The sorter ascending/descending order setting is made under
[Sorter Setup] (Other settings).
FILM ORIENTATION
CH01~16 : PORTRAIT
Sets the orientation in which film is printed.
"PORTRAIT"
: Film is printed in vertical orientation.
"LANDSCAPE"
: Film is printed in horizontal orientation.
POLARITY
CH01~16 : POSI
Sets image POSI/NEGA.
"POSI"
: POSI film is printed.
"NEGA"
: NEGA film is printed.
3.9 Print Condition Settings
The procedure for setting print conditions for each diagnostic device connected is described below. The
following print conditions may be set.
p.181 PRINT
CONDITION
(Web Mainte. Mode)
