Ch.4 Checking Image Quality
< 141 >
DRYPRO Vstage MODEL 793 Installation Manual Ver.1.00 2004.11
Upon completion of film
loading, the film count
value displayed in the
film information column
will change from "0" to
"126".
14
Push the supply tray back into the main body
until it locks in position.
- Pushing the tray back into its original position will
produce display of the message "The tray is
getting ready. Please wait..."
- Successful loading of the film will be followed by
display of the message "Ready" on the operation
panel, indicating that the device is ready to print.
13
Return the cutter to the cutter pocket (location 3 at
left).
15
Repeat steps
1
-
14
for each supply tray.
Procedure to be followed in the event that the [Film Setting] button does not
extinguish after loading film
- Forgetting to cut off the film package edge before inserting the film into the supply
tray and locking the supply tray will result in the [Film Setting] button being
displayed again.
(The film count value will be displayed as "0".)
Touch the [Film Setting] button again, pull out the supply tray and cut off the edge
of the film package.
- The [Film Setting] button will also be displayed if the package has not been
properly wound on (forgetting to insert the rear (far) edge of the package between
the hold down plate and the winding shaft), or if the first sheet of film has not been
successfully picked up. In such cases, the film should be reloaded.
In cases where the rear (far) edge of the package has not been properly inserted,
the part of the film package that has been cut open should be closed with tape to
prevent film fogging before opening the shutter to properly insert the package
between the hold down plate and the winding shaft.
