Ch.2 Unpacking and Installation
< 53 >
DRYPRO Vstage MODEL 793 Installation Manual Ver.1.00 2004.11
2.4.7
Replacing the Removed covers
This section describes procedures for replacing covers removed during work procedures.
1
Disengage the upper front cover disengaging
lever and open the upper front cover.
3
Pull out supply tray 1 to its fullest extent.
2
Disengage the supply tray 1 lock by inserting a
driver with a shaft length of 90mm or more into
the hole at the right side of the main body and
pressing down the latch.
- This will disengage the supply tray 1 lock.
4
Loosen the two screws (TP screws M3X6) and
remove the supply tray 1 cover.
5
If necessary, change the supply tray 1 film size.
p.77 Changing the
Supply Tray
Film Size
6
Remove the 2 top screws (TP screws M4X8)
and the two screws (TP screws M4X8) at the
edges (one at each edge) and remove the
supply tray 1 front cover.
