Ch.2 Unpacking and Installation
< 61 >
DRYPRO Vstage MODEL 793 Installation Manual Ver.1.00 2004.11
2.4.9 Installing HPRO Unit
After removing the heat-processing drum and checking for damage to any of the parts, the drum must
be re-installed without delay.
1
Holding the cable at the back of the heat-
processing drum in the left hand, place the drum
on the lower opposing rack.
Be careful not to
damage the heat-
processing drum.
2
Insert the protective film removed in "2.4.8
Removing Protective Sheet from HPRO Unit"
into the upper opposing rack as shown in the
left.
3
分離爪を手で浮かせて(1)、「2.4.4 露光部搬送ロ
ーラー保護フィルムの取り外し」で取りだした
フィルムを、上対向ラックの下の平らな場所に
突き当たる位置まで差し込みます(2)。
(1)
(2)
4
余ったフィルムをラック支持棒に交互に潜らせ
て固定します。
分離爪
ラック支持棒
