Ch.2 Unpacking and Installation
< 79 >
DRYPRO Vstage MODEL 793 Installation Manual Ver.1.00 2004.11
2.5.3
Changing Supply Tray Film Size Setting (14 inch tray only)
In facilities where 14X14" or 14X11" film is used, it is necessary to adjust the position of the size
stopper in the supply tray.
- The stopper position is set to 14X17" at the factory.
Since supply trays for small sizes (10X12" and 8X10") are designed specifically to accommodate
those sizes, no stopper adjustments are necessary.
4
Press lever-C and open the right cover.
3
Open the lower front cover.
1
Remove the cap at the bottom of the right cover of
the main body.
2
Disengage the lower front cover lock by
inserting a driver with a shaft length of 90mm or
more shown below into the hole revealed at the
right side of the main body by removal of the
cap and pressing down the latch.
- This will disengage the lower front cover lock.
Lower Front Cover Latch
90mm or more
Cap
