E-2
II. Confirmation before installation
1. When transporting the finisher, be sure to move it
in the direction illustrated below so as not to
deform the casters on the paper exit tray side.
2. Choose a horizontal and stable floor for installing
the machine.
3. The packaging material should not be reused for
repacking.
4. If the optional punch kit is to be mounted, first
install the punch kit before installing the finisher to
the machine.
III.Installation procedures
1. Turn off the machine and unplug the power cord
from the power outlet.
2. Remove the user’s guide holder from the
machine.
3. Remove the output tray (OT-503) if it is mounted
on the machine.
Note:
For the removal procedure, see the installation
manual for the output tray (OT-503).
4. Cut out the separator (one place) by using nip-
pers.
Note:
Be sure to remove the protective tape from the
machine after cut out the separator.
A07RIXC002DA
OK
NG
A07UIXC004DA
A07UIXC082DA
