E-6
(21) Verify items
➀
and
➁
below.
➀
The plate spring of the plate installed in step
(12) is contacted with the main body.
➁
When the lever that was pulled out in step (19)
is pushed back, the finisher’s screw hole is
within the range of lever’s mounting hole.
Note:
If there are any problems after verification, con-
duct the following steps a) to i).
a) Disconnect the connector, and remove the fin-
isher from the main body.
b) Slide the saddle unit out, and remove the cover
from the caster of the finisher. (Two screws)
c) Remove the rear cover from the finisher. (Eight
screws)
Screw
hole
Mounting hole
on the lever
➁
➀
< OK >
Contacted
Not contacted
< NG >
Plate spring