Contrast Shadow
– The relative contras
can be adjusted in 15 levels marked –7
Center Erase
– Take out the line betwee
Enable center erase –
With this chec
centerline.
t adjusting level for shadow output images. This setting
to +7.
n two pages from a book.
k box selected it enables the scanner to remove the
enter erase width
– Allows you to set the width of the centerline to erase.
Aut
y detects centerline erase position.
Th
The Action buttons allow you to interact with the driver User Interface to accomplish
important tasks or launch support windows. Here is a detailed description of what these
but
C
o erase position
– This automaticall
e Action Buttons
tons do:
the Scan button will cause the PS 7000 to initiate a scan using the
currently selected configuration. Scans can also be initiated by pressing the Start button on
Scan
– Clicking
the PS 7000’s front panel. When operating the PS 7000 in Batch Scan Mode (
see below
)
this button will be disabled and all scans must be initialized via the front panel Start button.
Scan All
– When the PS 7000 is set for Dual Scan Mode the Scan button will
change to a Scan All button. In addition to the Scan All button a Scan Left and a
Scan Right button will activate under the Preview Window. The user now has a
choice of three potential scan buttons. The Scan All button will cause the PS 7000 to scan
both the left and right half of the total scan area and return two separate images to the
application.
Note
:
If the scanning software being used does not support the
accepting of two or more image files from a single scan then most
likely only the rightmost image will be accessible in the application
software.
Preview
– Clicking the Preview button will cause the PS 7000 to perform a low-resolution
scan that will be displayed in the preview window. This scanned data is not transferred to
the application. The preview function is very useful for confirming scan settings and for
defining custom scans. To use previewing to define a custom area, first click the Preview
preview window just drag and drop or resize
AIN driver help file. This file contains
etailed information on working with the driver. Much of the information contained in this
guide can be found within the Help file.
button, once an image has been placed in the
the scan area to match the given portion of the preview image you wish to capture.
Cancel
– Use the Cancel button to close out the driver window without initiating any scans.
Help
– Clicking the Help button will launch the TW
d
Summary of Contents for MS 2000
Page 52: ......
