Dual In-Line Memory Module (DIMM)
75
Dual In-Line Memory Module (DIMM)
"
You may need additional memory for complex graphics, and for
duplex printing.
Dual in-line memory modules (or DIMMs) are compact circuit boards with sur-
face-mount memory chips.
Your printer comes with 32 MB SDRAM printer memory on board. However,
you can upgrade to a maximum of 160 MB of RAM through the installation
of an additional DIMM. Additional memory must be 128 MB DIMM. Your
printer comes with one available DIMM slot.
Installing a DIMM
Note
It is very important to protect the printer controller board and any
associated circuit boards from electrostatic damage. Before performing
this procedure, review the antistatic caution on page 74. In addition,
always handle circuit boards by the edges only.
1
Turn the printer off and disconnect the power cord and the interface
cables (if attached) from the printer.
2
Open the front cover.
3
Remove the screw on the back
of the right cover.
Summary of Contents for PagePro 1350EN
