3
Network Settings
3-10
Printer Controller Pi3505e Pi3505e/PS
3.5
Windows Printing
This section explains how to use Windows Printing Service for direct
printing on a Microsoft network.
Requirements
G
Computer must have NetBEUI protocol installed.
Configuring the controller
You need to perform the following PageScope Light procedure to
configure the controller for Windows printing.
1
Start up PageScope Light.
❍
See
“Using PageScope Light” on page 3-23
.
2
Input the correct password and log in to the Admin mode.
3
Click the
Network
tab, and then select
Common Settings
and then
Windows
.
4
Configure the settings described below.
* Changes in these settings do not go into effect until you turn the machine off and then back
on again.
Enable Windows Printing
Service:
Turns Windows Printing Service on or off.
NetBios Name*
Specifies the NetBIOS name (up to 15 characters).
Printing Service Name*
Specifies the Printing Service name (up to 13 characters).
WorkGroup Name
Specifies the work group name (up to 15 characters).
Summary of Contents for Pi3505e
Page 1: ...Printer Controller Pi3505e Pi3505e PS User Manual 4513 7734 01 www konicaminolta net ...
Page 11: ...x Printer Controller Pi3505e Pi3505e PS ...
Page 23: ...1 Before Using the Printer Driver 1 12 Printer Controller Pi3505e Pi3505e PS ...
Page 217: ...9 PS Utility 9 4 Printer Controller Pi3505e Pi3505e PS ...