4
Configuring PCL Printer Driver Properties for Windows
4-14
Printer Controller Pi3505e Pi3505e/PS
Output Setting Dialog Box
This dialog box appears when you click the
Detail of Output Setting
button on the
Setup
tab. You can use it to configure stapling, hole
punching, and folding.
(1)
Staple
This setting is available only when the Built-in Finisher (FN-117) is
installed on the machine. You can use it to staple the pages of one
printed document at a time.
• Off
No page stapling
• Auto 2-points
Pages are stapled at two points along the top
edge when landscape orientation is selected, or
along the left edge when portrait orientation is
selected.
• Top 2 points
Pages are stapled at two points along the top
edge.
• Left 2 points
Pages are stapled at two points along the left
edge.
• Corner
Pages are stapled in upper left corner.
If you have the Saddle Kit (SK-1) equipped on the Built-in Finisher
(FN-117) , you can also configure the following settings in addition
to those described above.
• Center
Pages are stapled in the center.
• Crease
You can select Crease for the (3) Fold setting.
(1)
(2)
(3)
Summary of Contents for Pi3505e
Page 1: ...Printer Controller Pi3505e Pi3505e PS User Manual 4513 7734 01 www konicaminolta net ...
Page 11: ...x Printer Controller Pi3505e Pi3505e PS ...
Page 23: ...1 Before Using the Printer Driver 1 12 Printer Controller Pi3505e Pi3505e PS ...
Page 217: ...9 PS Utility 9 4 Printer Controller Pi3505e Pi3505e PS ...