E-3
8. If the stapler unit is positioned toward the front of
the finisher, move it to the rear turning the dial
shown in the illustration.
9. Remove the C-clip from the supplied guide plate.
10. Attach the guide plate to the finisher.
Note:
Insert the two projections located at the end of the
guide plate into the holes on the plate inside the
finisher.
11. Open the guide plate and attach the C-clip
removed in step 9.
12. Remove seven screws that hold the cover
shown in the illustration on the left side of the fin-
isher.
Note:
A connector is connected to the cover.
13. Tilt the cover and remove the connector.
Remove the cover.
A3ERIXC010DA
Dial
A3ERIXC011DA
C-clip
A3ERIXC012DA
A3ERIXC013DA
A3ERIXC014DA
A3ERIXC015DA
