KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
11870-015-55 Rev.03 03-80-651-00 01/15
TECHNICAL DATA
11870 Orchestra music stand
A solid, versatile and gifted music stand for home, studio and stage
- Superior material mix
- transport friendly - thanks to the 3-fold aluminum tube combination
- the music desk is made of steel and is suitable for magnet holders
- the music desk is user friendly and equipped with a quick change bracket
-Height: 650 - 1500 mm, Music Desk: 340 x 490 mm, Weight: 2.8 kg
Material
Tubes, struts: Aluminum, Music desk: Steel
powder coating black
Brackets, handles: Polyamid (PA)
Joint: Polycarbonate (PC)
End caps, shock absorbers: (TPE)
Load
Sheet music, books, folders, etc.
Pack size
Stand: W x D x H: 100 x 100 x 655 mm
Weight
2,8 kg
Dimensions
Tube combination: ø 30/25/20 mm
max. base circumference ø 750 mm
Height: 650-1500 mm ( at max base circumference)
Music desk: 490 x 340 x 50 mm
Accessories
(optional)
Carrying case 11450
Sheet music trays 122a, 12218, 131
Eye glass holder 16050 among others,
Magnets 11560, 11580
HEIGHT
STAND
ANGLE
MUSIC
DESK
SETUP INSTRUCTIONS
SAFETY NOTES
Thank you for choosing this product. The instructions provide
directions for the important set up and handling steps. We
recommend you keep these instructions for future reference.
FUNCTIONS
HEIGHT ADJUSTMENT
NOTE:
Prior to loosening the clamp screw
9
hold the extension tube in one hand.
1
9
Loosen the clamping screw of the clamp/bracket;
10
Adjust the extension tube to the desired height
11
Re-tighten the clamp screw.
THE ANGLE OF THE TABLE
12
Loosen the wing nut,
13
Place the table at the desired angle,
14
Re-tighten the wing nut.
The setup of the orchestra music stand only
requires a few steps:
STAND:
1
Loosen the adjustment screw a bit,
2
Expand the legs until...
3
...the connecting struts are level.
4
Re-tighten the clamping screw.
4
NOTE: Manual strength is enough;
4
Do not over-tighten the screws it can
4
negatively affect the components.
MUSIC DESK:
5
Flip up the gray clamp lever,
6
Place the slide bracket all the way...
7
...into the bracket on the stand.
8
Secure the connection by flipping the
8
gray lever down.
Disassembly is performed
in the reverse order.
- Center the weight bearing load
- Be sure that the surface is suitable and level
- The fact that the product is collapsible and adjustable
-
can result in the risk of the pinching/wedging of fingers.
-
Careful and attentive handling during setup, operation,
-
and disassembly is indispensable
