KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
16320-000-55 Rev.10 03-80-110-00 11/12
16320 Universal mount
Full-swivel holding bracket:
-
- place in position for use
-
- compact when not required
- rubber-covered, protective surface
- secure and robust steel core
SAFETY NOTES
Thank you for choosing this product. This instruction manual informs you about the important
steps to set up and handle the product. We recommend to keep the manual in a separate
place for a possible later use.
- Not to be used in external or damp areas.
- Ensure the product is attached in a way suitable for the given conditions (possibly differing from the EXAMPLES FOR ATTACHMENT, see below).
- Only attach to a wall which is suitable using suitable materials (not included in the delivery).
- Walls which are too weak or in which electric cables or water pipes are located are unsuitable. If in doubt consult a qualified technician.
- Regularly check the holder to ensure it is still properly attached.
- Avoid the risk of pinching by moving the holder with care.
INSTALLATION INSTRUCTIONS
1. Line up the wall plate vertically,
1.
mark the drill holes
1. MOUNTING
2. EXAMPLES FOR ATTACHMENT
3. DIMENSIONS & POSITIONING
a. Concrete wall, solid masonry:
a.
plastic rawl plugs, ø 6 x 36 mm
drill, clear debris by blowing in hole, hammer in the
rawl plug, position wall plate, screw in the screws
b. Perforated brick: plastic anchor 8 x 80 mm
drill and ream hole, clear debris in hole by blowing, push in rawl
plug, position wall plate, screw in screws
c. Wood beam: wood screws
DIN 571 ø 5 x 50 mm
drill and ream, position wall plate,
screw in screws
d. Wood beam:
wood chip screws ø 4.5 x 40 mm
no pre-drilling, position wall plate, screw in
screws
Swivel bar to required position.
Projection only 24 mm – when not in use.
2. Pre-drill two holes:
2.
- ø 6 mm for equivalent size
2. -
a. Plastic rawl plugs (concrete, solid
2. - a.
masonry)
2. -
b. Plastic anchor (perforated brick)
2.
- ø 3.5 mm for size 5 mm
2. -
c. Wood screws DIN571 (beams)
2.
- pre-drilling unnecessary for
2. -
d. Chipboard screws
INSPECTION, MAINTENANCE, CLEANING
TECHNICAL DATA
- Check the functioning of the screws regularly.
- For cleaning purposes utilise a slightly damp cloth with a non-abrasive cleaning
solvent.
FAULT FINDING (FF) & SOLUTION (S)
FF: Bar swivels at will
FF:
S: Wall plate is not vertical, straighten.
FF: Bar can be removed from the wall plate
FF:
S: Are the safety rings missing? Replacements: Art.No.03-12-590-00
Material
Wall plate, bar, safety rings - steel
Sheathing - TPE 089
Distance sleeve - PA-GV
Load
e.g. Headphones, cable etc.
Dimensions
B x D x H 40 x 153 x 90 mm
(package size: 24 x 160 x 90 mm)
Packing
PE bag with cardboard header: 200 x 270 mm
