17630 Guitar Station M
17640 Guitar Station L
INTENDED USE
Free standing guitar stand with hanger (retaining bracket) to hold the instrument.
FEATURES & CAPABILITIES
- Representative design - with or without guitar
- Due to the flexible, adjustable hanger the stand is devised for (almost)
-
all acoustic and electric guitars
- Generously dimensioned base to ensure a secure hold
- Optics: slim silhouette in high-gloss black
SAFETY INSTRUCTIONS
- The product consists of several components which should be screwed together on
-
site in compliance with these instructions. The following is required:
-
a. physically fit and technically competent manpower
-
b. suitable tools (supplied, see: Chapter 1
s
,
t
)
-
c. careful procedure (do not drop the base plate /
-
c.
work with several people / wear gloves)
- Ensure that the surface is suitable, i.e., stable and level.
- Place the instrument carefully in the yoke.
-
First check if the guitar neck fits and a secure hold is warranted.
-
Experience has shown that this is the case regarding most but not
-
all guitar models.
- We assume no liability for damages caused due to the fact that the guitar
-
is not suitable or has not been correctly fitted.
SET-UP INSTRUCTIONS
TECHNICAL DATA
Thank you for choosing this product. Please read and follow the instructions carefully.
They inform you about all the important steps concerning assembly and handling.
We recommend you to keep them for future reference.
Material
Base, columns, connectors, head: Steel,
powder-coated
Screw connections: Steel,galvanised
Legs, protective caps, yoke pads: Plastic
Parquet protection: Felt, black
Load capacity
Guitars, bass guitars
Dimensions
Base: W x D x H: 360 x 440 x 23 mm
Yoke: inside max. 65 mm
Yoke to the floor:
17630 = 980 mm / 17640 = 1120 mm
Total stand height gesamt:
17630 = 1210 mm / 17640 = 1350 mm
Carton
B x T x H: 545 x 520 x 50 mm
Weight
17630 = 9 kg / 17640 = 10 kg
1. COMPONENTS (see back side)
2. ASSEMBLY and MOUNTING (see back side)
3. GUITAR YOKE
3.1
The generously dimensioned yoke is designed for most
3.1
types of guitars.
3.1
NOTE:
We cannot exclude the possibility that there
3.1
NOTE:
might be some models that do not fit.
3.2
The two retaining brackets can be rotated
3.2
independently.
3.3
Especially asymmetrical guitar necks can be adjusted
3.3
without any problems. Precondition is the saddle thick-
3.3
ness of the guitar (between neck and head).
3.4
Both yokes have an unbreakable steel core which
3.4
is completely covered with a rubber-like protective layer.
3.5
The weight of the instrument causes that an additional
3.5
clamping effect is triggered due to the mobile bracket.
3.5
HANGING THE GUITAR
3.6
Place the neck of the guitar into the yoke and lean
3.6
crosswise against the back end. Then place both yokes
3.6
on the saddle of the guitar (see
3.3
). Carefully release
3.6
the instrument and check if the hold is secure.
KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
17630-000-37 / 17640-000-37 Rev.05 03-80-030-00 7/21
3. GUITAR YOKE
