TECHNICAL INFORMATION / SPECIFICATIONS
INSPECTION; MAINTENANCE; CLEANING
- While servicing, be careful not to trap fingers, etc.
- To clean, use a slightly damp cloth and non-scouring cleaning solution.
PROBLEMS and SOLUTIONS
Q: Stand wobbles on the floor - A: Re-set the parquet protectors, inspect floor
Q: Height/width of the stand incorrect - A: Change hole-setting (normal or extremely low), position connector struts
Q: Keyboard wobbles on stand - A: Adjust/ re-position rubber pads
Q: Stand is folded, but the - A: Reposition connector struts to the same hole pair
Q:
connector struts stick out
Material
Steel tubes and steel struts – black powder coated
Screws, bolts – zinc plated, nickel plated
Parquet protectors, rubber pads – Evoprene 089, Shore 59A black
Clamping nut – PA, brass
Weight capacity
max. 50 kg
Dimensions
height (support surface width): variation A- min. 540 (635) mm / max. 755 (370) mm;
variation B- min. 210 (640) mm / max. 680 (395) mm
Package
H x W x D: 840 x 465 x 70 mm; carton: 1010 x 465 x 70 mm
Mount weight
3.0 kg
7. To adjust to the keyboard, two of the four rubber pads can be repositioned. It is often enough simply to push them a little (7.1),
7.
if necessary, they can also be repositioned on one side of one of the bearing tubes (7.2-7.3-7.4).
8. When folding, push the connector
8.
struts down slightly, being careful not
8.
to trap fingers, then hold the stand by
8.
the support tubes and close together.
8.
IMAGES of the stand when collapsed:
8.
8.a:
8.
Same hole number for the connector struts
8.
8.b:
8.
Uneven hole number (note: error!)
KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
18969-071-55 Rev.07 03-80-169-00 10/19
USER INSTRUCTIONS / FUNCTIONS
