Lifting the load
✓
The stand is securely set up.
✓
The stand tube is in the lower end position.
✓
The clamping screws are tightened.
✓
If the load is within the range of movement of the crank, the extension tube must be free by
✓
approx. 100 mm before placing the load.
Lowering the load
✓
The stand is securely set up.
1
Place the load.
2
Loosen the clamping screw of the crankcase.
3
Turn the hand crank clockwise until the desired
3
height is reached.
4
Tighten the clamping screw.
1
Loosen the clamping screw of the crankcase.
2
Secure the hand crank with one hand and the
2
crankcase with the other. Lift the load slightly to
2
relieve the release button. To do this, apply pres-
2
sure to the crank in a clockwise direction.
3
Press the release button with your thumb.
4
Turn the hand crank anticlockwise and lower
4
the load.
5
Release the release button.
6
Tighten the clamping screw.
22
