KÖNIG & MEYER
GmbH & Co. KG
Kiesweg 2, 97877 Wertheim, www.k-m.de
17650-000-55 Rev.01 03-80-336-00 3/18
SAFETY NOTES
SETUP INSTRUCTIONS
Thank you for choosing this product.The instructions provide directions to all of the
important set up and handling steps. We recommend you keep these instructions
for future reference.
- Be sure that the surface will bear the load and is suitable and level.
- Carefully set or lean the instrument into the neck support.
- The fact that the product is collapsible and its width is adjustable bears the risk of
-
pinching or wedging one's hands and/or fingers; careful and attentive handling during
-
setup, operation and disassembly is indispensable.
- Where guitar and stand contact, felt pads form a protective cushion. These are neutral
-
to the instrument surfaces, i.e. they do not bite them. Please note, however, that some
-
surfaces (particularly nitrocellulose) are relatively soft and just placing an instrument on
-
the stand can leave marks. The cause of the marks is, however, not a chemical
-
reaction, rather it is just a matter of gravity.
17650 Guitar stand »Carlos«
- Unique guitar stand in an attractive design
- Equally suited for acoustic and e-guitars
- The special complete-construction stands for functionality and stability.
- The instrument is protected through felt covered support arms that
-
protect the guitar from scratches and damage.
- The neck closure locks when putting the guitar onto the stand and
-
provides a safe and secure hold.
- Ideal for transportation: quick setup and disassembly, very flat transport
-
footprint.
- Very easy in setup and use (tools not required)
1. PACKAGING
2. SETUP STAND
Box 820 x 530 x 95 mm
1. PACKAGING
The »Carlos« packaging is characterized by
it’s extremely flat silhouette.
It is only 86 mm.
2. SETUP STAND
Setting up »Carlos«
is very easy.
All components are
pre-assembled and
the system only has to
be placed in the desired position
2.a
After the stand has been
taken out of the box,
grab onto the support struts
at the bottom of the stand
and pull out from the grid
2.a.1
2.b
Hold on to the support from the top
and also pull the support away
from the grid
2.b.1
Then turn the support 270°, i.e.
three-quarters of one turn
2.c
Place the support strut into
the “keyhole” as far
as it will go
2.d
Fold the neck support upwards
approx. 90° into the upper shaft
2.d.1
of the stand until it clicks into place
