Step 6: Align the board with the connections in the back plate and close the enclosure.
For CMP-MOBPLAY30:
Step 1: Open the enclosure by unscrewing the back panel and pulling out the board.
Step 2: After removing the board, connect the data and power cables to the hard drive and
slide it carefully onto the board.
Step 3: . Connect the hard drive to the board using the screws.
-3-
Step 4: Gently slide the board with the hard drive connected to it back into the aluminum
enclosure. Close up the enclosure with two screws on each side of the back plate.
4. Connections
For CMP-MOBPLAY10:
The enclosure has the following connections and buttons:
-
Backup button (used for back-up software on PC)
-
Switch (to choose between TV/Off/USB mode)
-
USB 2.0 connection
-
Video output connection
-
Audio output connection
-
5V Power connection.
If you want to use your media player as a USB 2.0 storage drive, then put the switch to USB
mode. If you want to switch off the player, set the switch to Off mode. Finally, if you want to
use the media player to display multimedia on TV, then set the switch to TV mode.
For CMP-MOBPLAY30:
The enclosure has the following connections and buttons:
-
Copy button (used for back-up software on PC)
-
USB 2.0 connection
-
Video output connection
-
Audio output connection
-
Power connection.
-4-
EN
EN
