4
2. To clear all favourite channels: Under the “Favourite channel” setting mode, press and
release the “FAV” button until the indicator light flashes three times. This indicates that
the information in the setting is completely cleared. Press the TV button to exit.
Multi-Function Button Setting
There are two multi-function buttons on the remote control: M1 and M2. Each
multi-function button can store data for 20 buttons. You can use this function to combine
the functions of a series of different buttons or commonly pressed buttons into one single
button. After the setting has been completed, press the multi-function button that was
previously set. The remote control will emit the control codes of the buttons that were
previously set in the correct order. This simplifies operation.
For example: Switch on the power of the TV set
and switch to TV/AV.
1. Press the “TV” button. Select the home appliance that you wish to set.
2. Press and hold the “” and “” buttons at the same time until the
indicator is switched on. Then release both buttons (the indicator light will switch off
and then on again).
Enter code 9991 manually. The indicator light will light up to indicate the start-up of M1
setting. (9992 is the corresponding code for M2 setting).
3. Press the “POWER” button to indicate that TV power data has been entered into M1.
Press the TV/AV button to add another set of codes (every time you press a button, the
indicator light will flash once).
4. Press the “TV” button. The indicator light switches off. Exit settings.
NOTE: After exiting the multi-function settings, the remote control will revert to the
pre-multi-function setting mode. The remote control will have no connection with the home
appliances selected. Point the remote control at the TV set and press the “M1” button (for
all kinds of home appliances). The remote control will emit data code in this order:
“TV power”
“AV/TV”
Clear Multi-Function Button
Setting Method:
1. Under the multi-function setting mode, press the corresponding M1/M2 button. This
eliminates a command button. After the multi-function button data is cleared, the
indicator light will flash three times.
2. To completely clear the multi-function button: Under the multi-function setting mode
press and release the multi-function button “M1/M2” until the indicator light flashes
three times. This shows that all functions have been cleared. Press any button to exit.
Maintenance:
Clean the product only with a dry cloth.
Do not use cleaning solvents or abrasives.
Warranty:
Any changes and/or modifications to the product will void the warranty. We cannot accept
any liability for damage caused by incorrect use of this product.
Disclaimer:
Designs and specifications are subject to change without prior notice. All logos, brands
and product names are trademarks or registered trademarks of their respective holders
and are hereby recognised as such.
Disposal:
• This product is designated for separate collection at an appropriate collection
point. Do not dispose of this product with household waste.
• For more information, contact the retailer or the local authority responsible for
waste management.
