18
If you have another HDD, please jump that HDD to SLAVE, and open the machine, put
the HDD to the HDD shelf, then connect the power and digit cable.
2. Normal Recording
Check recording parameter setup before recording; select video quality, frame rate.
You can’t change record setting during the process of recording.
Manual recording belongs to normal recording. Under the manual mode (non-schedule
status), pushing record button to record all channels’ video and push the record button
again to stop.
During the process of recording, if the hard disk is full, and the system is set to
automatic overwrite, then the recording will not be interrupted, and it begins to overwrite the
earliest recorded area; if the system is set to overwrite disable, it will stop recording.
NOTE:
if you have two hard disks, one is master; the other is slave. The DVR will be
not record on slave disk until the master disk is full.
3. Alarm Recording
●
check whether the connection of alarm input equipment is correct, stable and
reliable, and the alarm set is right, please refer to “sensor set”.
●
Turn on the “EVENT REC TIME” first, otherwise it doesn’t recording. If you want to
hear the alarm, please turn on the “BUZZER SOUND”. For sensor alarm, “alarm
enable” of that channel must set to “ON”; for motion alarm, “motion enable” of that
channel must set “ON”, and set the right area for motion detect.
●
Check “RECORD SET” before recording; Confirm the video quality and the frame
rate; the record setting cannot change during recording process.
●
As long as the alarm input signal is effective, the alarm recoding continues, When
the alarm input signal loses efficacy, the time set up by “EVENT REC TIME” becomes
effective, and when the time goes out, the alarm recording automatically stops.
4. Time Recording
●
Time recording starts and stops automatically according to the pre-arranged time in
schedule timetable.
●
Push down the “SCHDULE” button on the front panel or remote controller to set
schedule on. While pushing down this button, the schedule symbol “*SCHEDULE
