24
11. PTZ OPERATION
This DVR can control high-speed domes, which are connected to the DVR.
To control the high-speed dome, make sure all the wires are correctly connected, first
you must set the right
protocol,
baud rates,
and
high-speed dome’s address
for each
speed dome, please refer to protocol set.
PTZ can only be operated by remote controller, press the PTZ button on the remote
controller, “PTZ” will be display on the screen, then select 1 to 4 to choose PTZ channel,
the channel number will be displayed after “PTZ”. You can press “Up, Down, Left, Right”
button to move the high-speed dome, and press the button again to stop. If you press the
IRIS button, the characters “IRIS” will be appear on the screen, then you can press the
“SET+/-” button to change the IRIS, the same to control the “Focus, Zoom, and Speed”,
also press this button again to stop.
Press the PTZ button again to exit PTZ mode.
NOTE: if all the connect are correct, but the high speed domes doesn’t work, please
change the “protocol,
baud rates,
and speed dome’s address” to try.
12. PIP MODE
3 Picture In Picture Mode
CAMERA 1
CAMERA 3
06/28/2002 07:25:56
CAMERA 2
CAMERA4
Push “PIP” button, the DVR will be in PIP mode. You can re-push this button to change
the PIP mode (one picture; two or three picture). Long press “PIP” key on keyboard or “PIP-C”
