KONLEN TECHNOLOGY LIMITED
Website: www.konlen.com
U1 building, Oriental Garden, NanShan District, Shenzhen City, Guangdong Province,China
Tel: +86-(0)755-86082432 E-mail:
klalarm@konlen.com
MSN:
konlensales@hotmail.com
Skype: securitykonlen
- 3 -
1.
Insert SIM in alarm unit.
Press yellow point gently with a pencil tip. SIM tray will come out.
Put the SIM in it and insert in back.
Attention! Metal contacts of the SIM must be down. Check it to be inserted correctly in the unit.
Before insert SIM in alarm unit, using a regular mobile phone do the following steps:
-
Set PIN code request to off.
-
Delete all stored numbers
-
Store only numbers desired for alarming (up to 5 numbers). Numbers must be inserted in
order of calling. First stored will be first called, second stored will be second called and so
on.
2.
Connect the antenna.
Attention! Be careful, do not over-tighten the nut or let it loose!
3.
Connect the siren to alarm system: connect red wire to ground (public) port
and black wire to siren port.
Siren
4.
How to distinguish 8 LEDs on the main panel?
OUT1, OUT 2 and OUT 3: show the status of output 1,2 and 3. They can be used to three lights
or other home appliances.
RELAY: The fourth LED. It shows relay status. There is a on-board relay inside. The Relay LED
will be on when the relay’s two ports are closed.
ALARM: The fifth LED shows the working status of siren. If siren is triggered, the “Alarm” LED
will be on.
MONITOR: When it is on, it means the system is in the status of listening-in.
