Könner & Söhnen KS 15TKG 52/35, Owner'S Manual

REGULAR MAINTENANCE CHECKLIST

10

Comply with the instructions in this manual! You can find an updated list of service centers on the website of exclusive 

importer:

 www.ks-power.de/en

   MAINTENANCE OF AIR FILTER

MAINTENANCE OF AIR FILTER

A dirty air filter restricts air flow into the carburetor, decreases engine 

performance and reduces log splitter performance. Check the air filter 

and clean it before every start. If the air filter is damaged, replace it. When 

working in extremely dirty conditions, clean the filter every 10 hours, 

otherwise replace it every 25 hours if needed.

Never operate the engine without 

air filter. The air filter prevents 

high-speed wear of the engine.

IMPORTANT!

paper 

element

rubber gasket

   SPARK PLUG MAINTENANCE 

SPARK PLUG MAINTENANCE 

Spark plug must be intact, free of soot deposits and must have a correct gap.
SPARK PLUG CHECK:

SPARK PLUG CHECK:

1. Remove the cap from the spark plug.
2. Remove the spark plug by means of a corresponding spanner.
3. Examine the spark plug. If it is shattered, it is necessary to replace it. Recommended replacement spark plugs – 

F7RTC

.

4. Measure the gap. It must be within a range of 0.7 – 0.8 mm.

5. In case of repeated use, the spark plug must be cleaned with a metal brush. After that set the correct gap.
6. Put the spark plug back in its place by means of a spark plug spanner.

7. Replace the spark plug cap.

www.ks-power.de/en

|

    11

Attach the engine to the engine setting board using hex bolt 

M8, the flat washer, lock washer, and lock nut.

Attach all the hoses to the machine as shown below, 

including hydraulic oil hose A, oil hose B, oil hose C and 

oil suction pipe.

1. Attach the left fender and the right fender to the oil tank 

using hex bolt M8, flat washer Ø8, and lock nut M10.
2. Attached the left and right log cradles using bolt M10 

and lock nut M10.

STEP 9: 

STEP 9: 

ATTACH THE WHEEL FENDER AND LOG CRADLE

ATTACH THE WHEEL FENDER AND LOG CRADLE

STEP 10: 

STEP 10: 

ATTACH BIG TABLE

ATTACH BIG TABLE

Bolt 

М10х25

Bolt

 М10х25

Lock Nut 10

Washer 10