Könner & Söhnen KS 15TKG 52/35, Owner'S Manual

All bearings of your splitter are sealed units and should 

be sufficiently lubricated to last the life of your machine 

with normal use.

The rack and pinion should be completely greased before every use. Before performing any 

maintenance procedure or inspection, stop the engine, wait five minutes to allow all parts 

to cool. Disconnect the spark plug wire, keeping it away from the spark plug.

WARNING!

The equipment is sold without adaptation to the rules 

of operation and transportation on public roads. In each 

country, the responsibility for the adaptation rests solely 

with the buyer.

WARNING!

Before long-term storage of the log splitter during the en-

gine work close the fuel valve and let the engine to elabo-

rate gasoline from carburetor. Wait until engine stops itself.

IMPORTANT

  LUBRICATION

LUBRICATION

Before performing maintenance, the hydraulic log splitter must be placed in maintenance mode.
1). Turn off the engine.
2). Move the control valve handle forward and backward to relieve hydraulic pressure.
After performing maintenance, make sure all guards, shields, and safety features are put back in place. 

Failure to follow this warning can result in serious injury.

PROCEDURE

Every start

or 20 hours

Before each 

use

Every 5  hours

Each 3 months 

or after 50  working hrs

Each 6 months  or after 100  working hrs

Every year  or after 150  working hrs

Motor oil

Check

Replace

Hydraulic oil

for model KS 27THG 65/55

Check

Replace

Air filter

Check

Clean out

Replace

Check general equipment

Check

Grease surface of slide rail 

Lubricate

Check belts

Check

Grease rack and pinion

Lubricate

Clean engine exterior and 

cooling

Clean out

Spark plug

Gap check and 

control

Replace

www.ks-power.de/en

|

    12