15
TRADITIONELLE DEUTSCHE QUALIT
AT
· ·
CULTIVATOR OPERATION
COMMISSIONING
During the commissioning:
1. Fill the crankcase with oil (0.6 L)
2. Fill the fuel tank with gasoline (0.4 L for KS 4HP-45; 0.45 L for
KS 5HP-65)
USEFUL TIPS
1. To determine the plowing depth, use the coulter at different heights. With the
coulter driven deeper into the soil, the cutters also go deep into the soil and the
advancement of the device forward slows down considerably.
2. The cultivator speed is determined by adjusting the engine speed. The cutters
go deep into the soil with the device in the fixed position.
3. To speed up the cultivator advancement, adjust the coulter higher to lift the
cutters.
4. Dry and hard ground may possibly contain big lumps and thus require two
passes. Do not process raw soil, because it is difficult to break loose.
5. Immediately release the clutch lever when the cultivator is blocked by
foreign objects. Kill the engine, remove obstacles and check the cultivator for
deformation and damage. Replace damaged parts as necessary.
FUEL AND OIL
The cultivator requires unleaded gasoline with an octane number of
92. Only use fresh, premium-grade gasoline. Use a funnel (not included) to refuel
the device.
Just like without fuel, the cultivator cannot work without oil, so be sure to fill
the oil tank before the first start. To do this, place the device on a flat horizontal
surface, open the oil tank cap and add the oil to the minimum mark. Use the oil
dipstick to check the oil level. The oil filling level must be monitored at all times.
Do not exceed or fall short of the oil level. Information on the used engine oil can
be found in technical data of the cultivator.
Fig 13
