Könner & Söhnen KS 600RTG, Manual

 FUEL AND ENGINE OIL

FUEL AND ENGINE OIL

Only unleaded gasoline is recommended for the tiller.

 Gasoline should be fresh. Use a funnel 

(not supplied) for best device filling. 

The tiller also can not run without oil, so fill it before the first launch. Set the device on a flat horizontal 

surface, open the tank with oil and pour oil to the minimum mark and add fresh oil to the mark between 

MIN and MAX. Use the probe to check the oil level. Oil level must be constantly monitored. Do not let excess 

of oil and its lack. Information on used motor oil can be found in the technical characteristics of the tiller.

 STARTING THE ENGINE

STARTING THE ENGINE

Before starting the engine, make sure the switch is in position I (ON) (see the pictures below). Turn the 

rotary engine speed dial to MAX. Damper motor switch to position CHOKE. Grasp the starter handle and 

slowly pull it to the emergence of resistance, then sharp fast motion pull starter all the way. Repeat the 

operation until the engine starts. After starting the engine let the rope to entangle on trigger without 

throwing the starter handle. Put the flaps in position RUN.

air damper

fuel valve

throttle governor

MAX

MIN

Engine switch

OFF

ON

The engine switch is located 

on the control panel handle.

starting

grip

Open

Close

Open

Close

Сlutch lever

  FORWARD MOVEMENT

FORWARD MOVEMENT

1. Set the gearshift lever to the “+1” or “+2” or “+3”) position.
2. Gently press the red fuse (near the clutch lever), press and hold 

down the clutch lever ( see picture). 

For model KS 7HP-1050G – see Fig. 5 on Section 7

 in the Appendix.. 

  CLUTCH ADJUSTMENT

CLUTCH ADJUSTMENT

If extraneous sounds are heard when pressing, or the clutch lever is 

pressed hard, or the cultivator does not move when the clutch lever 

is pressed. Most likely you need to adjust the tension of the clutch 

cable. The cable must be adjusted with the cultivator switched off.

konner-sohnen.com

|

    8