22
494326/A
Connecting the system cables
All relevant wires in the pigtail cable must be terminated before connecting the system
units. Make sure all wire terminations have been performed correctly.
Procedure
1
Connect the pigtail cable to the transducer. (C1)
2
Connect the ethernet cable to the pigtail and to the Computer. (C2)
3
Connect the DC power cable to the pigtail and to the Power Supply Unit. (C3)
An optional Responder Driver Unit together with an Ethernet Switch may be part of
the system. If this is the case, see steps 4-10.
4
Connect the responder sync cable to the Responder Driver Unit and to the pigtail.
(C4)
5
Connect the Ethernet cable to the Responder Driver Unit and to the Ethernet
Switch. (C5)
6
Connect the Ethernet cable to the Ethernet Switch and to the pigtail. (C6)
7
Connect the Ethernet cable to the Computer and to the Ethernet Switch. (C7)
8
Terminate the responder trigger signal cables with D-sub connectors. (C10-11)
For more information, see
Pinout responder trigger signal cables with D-sub
9
Connect the responder trigger signal cables to the Responder Driver Unit and to the
responders. (C10-11)
10
Connect the responder trigger signal cables to the Responder Driver Unit and to the
responders. (C12-15) Use fibre to electrical signal converters if necessary.
µPAP 201-C Instruction manual
Summary of Contents for mPAP 201-C
