page 11
KP Strong Safe, grade II
Warning:
Make sure that the ends of the battery with positive and negative polarity are matched correctly,
as marked in the battery compartment. If the battery is installed incorrectly, running the lock will not be
possible.
There are locks supplied more than one battery, in such cases, replace all the batteries at the same time. Do
not mix old and new batteries or mix batteries of different types (for example, alkaline and lithium batteries).
Batteries should not be opened, punctured, loaded, installed, or exposed to fire, heat or water. It is
recommended to only use alkaline or lithium batteries of known brands.
Adjustment of hinges
KP Strong Safes have external hinges.
To make an adjustment you need two hex keys of size 4mm.
Fig. 3 Upper hinge
Adjustment of hinges is performed as follows:
1.
Remove the plug (4) from the upper hinge.
2.
Height adjustment of the door (2) is done by using the adjustment screw (3) by turning the hex key
4mm. Lifting of the door is done by turning the screw clockwise. Lowering of the door is done by
turning the screw (3) in the opposite direction.
3.
Use glue to secure the thread from the unscrewing the screw (3). Before adjusting unscrew the
adjustment screw (3) and apply onto the thread a few drops of thread glue (permanent joints)
4.
Insert the plug into the hinge hole (4).
Adjustments is performed so that the slots on the top and bottom of the door were equal (control on half
closed door of the safe). In case of problems, please contact the Service.
