Safety Instructions
6
V Box Express – User’ Manual
Safety Instructions
Please read this section carefully and observe the instructions for your own safety
and correct use of the device.
The chapter also contains information on approval and interference suppression
of your device.
Observe the warnings and instructions on the device and in the manual.
The device has been built and tested by Kontron Embedded Computers in
accordance to EN 60950-1 and left the company in a perfectly safe condition.
In order to maintain this condition and ensure safe operation, the user must
observe the instructions and warnings contained in this manual.
The device must be used in accordance with the instructions for use.
The electrical installations in the room must correspond to the requirements of
the respective regulations.
Take care that there are no cables, particularly power cables, in areas where
persons can trip over them.
Do not use a power cable in sockets shared by a number of other power
consumers. Do not use an extension cable.
Only use the power cord supplied.
Do not place the device in direct sunlight, near heat sources or in a damp
place. Make sure the device has adequate ventilation.
Only devices and components which fulfill the requirements of an SELV circuit
(safety extra low voltage) in accordance with EN60950 may be connected to
the interfaces of the system.
All plugs on the connection cables must be screwed or locked to the housing.
The device is designed to be used in vertical position with the interfaces to the
front.
