COMe Ref. Carrier-i T6 TMI - User Guide Rev. 1.4
// 23
2.2.
Graphics Inter faces
2.2.1.
Digital Display Interfaces
The COMe Ref. Carrier-i T6 TMIP provides the following digital display interfaces (DDIs):
DDI1 from the COMe module is directly mapped to the Disp+ connector, J12, through a redriver IC, U5
DDI2 from the COMe module is directly mapped to the Mini Disp+ connector, J17,through a redriver IC, U9
DDI3 from the COMe module is directly mapped to the Mini Disp+ connector, J16,through a redriver IC, U7
2.2.2.
LVDS/eDP Interface
The COMe Ref. Carrier-i T6 TMIP supports a 24-bit, dual-channel LVDS interface via the LVDS/JILI connector, J8.
The following table provides pinout information for the LVDS/JILI connector, J8.
Table 7: LVDS/JILI Connector J8 Pinout
LVDS/JILI Connector (J8)
Pin
Signal
Pin
Signal
1
LVDS_BKLT_CTRL
21
2
LVDS_A0-
22
GND
3
23
LVDS_B2-
4
LVDS_VDD_EN
24
5
LVDS_A1-
25
GND
6
26
LVDS_B_CK-
7
NC
27
LV
8
LVDS_A2-
28
GND
9
29
LVDS_B3-
10
GND
30
11
LVDS_A_CK-
31
+5V
12
LV
32
+5V
13
GND
33
+5V
14
LVDS_A3-
34
+5V
15
35
LVDS_BKLT_EN
16
LVDS_I2C_DAT
36
GND
17
LVDS_B0-
37
GND
18
38
+12V
19
LVDS_IC2_CK
39
+12V
20
LVDS_B1-
40
+12V
If eDP support is required, the COMe Ref. Carrier-i T6 TMIP may optionally be equipped with a Mini Disp+
connector, J9, instead of the LVDS/JILI connector, J8.
To use the eDP interface, the COMe module installed must also support eDP.
