Introduction
EBC2
Page 1 - 14
© 2005 Kontron Modular Computers GmbH
ID 29022, Rev. 01
26873
.02.VC.050120/135420
P R E L I M I N A R Y
Table 1-3: EBC2 Interfaces and MC Elements
IF / MCE
ALIAS
DESCRIPTION
BT1
Backup battery for RTC, SRAM, etc.
D2
12V
LED, green, indicates 12V input power is applied
D4
5V
LED, green, indicates 5V power is applied
D5
3.3V
LED, green, indicates 3.3V power is applied
D9
DIN0
LED, green, indicates DIN(0) signal is asserted
D10
DIN1
LED, green, indicates DIN(1) signal is asserted
D11
DIN2
LED, green, indicates DIN(2) signal is asserted
D12
DIN3
LED, green, indicates DIN(3) signal is asserted
D13
DOUT3
LED, yellow, indicates DOUT(3) signal is asserted
D14
DOUT2
LED, yellow, indicates DOUT(2) signal is asserted
D15
DOUT1
LED, yellow, indicates DOUT(1) signal is asserted
D16
DOUT0
LED, yellow, indicates DOUT(0) signal is asserted
D17
GPIO
LED, red, general purpose IO signal, when on signal is asserted (MC11)
D18
WDOG
LED, yellow, indication is a function of the E²Brain™ module Watchdog logic(MC7)
D19
BOOT
LED, green, indication is a function of the NetBootLoader during system booting, is
available to the application after booting is completed (MC6)
D20
POST_HI
LED, seven segment, hexadecimal display, higher nibble of byte, used for indicating
POST codes or application after system is booted
D21
POST_LO
LED, seven segment, hexadecimal display, lowerer nibble of byte, used for indicating
POST codes or application after system is booted
J1
TSE[1, 2]
Connector, dual RJ45, three speed Ethernet interface, right connector is TSE1, left con-
nector is TSE2 (as seen from front of connector - LEDs visible)
J2
+12Supply
Connector, +12V main input power supply
J3
TERM
Connector, serial interface for terminal operations
J4
M/C
Connector, external access to monitor and control signal lines
J5
ATMEL
Connector, programming interface for E²Brain™ module logic configuration EEPROM
J6
TP1
Connector, test and programming interface for EB405 and EB8540 E²Brain™ modules
J7
TP2
Connector, test and programming interface for EB425 E²Brain™ module
J8
CONS
Connector, serial interface for console operations
J9
INT2
Jumper, test interface, interrupt input source, active low
J10
INT1
Jumper, test interface, interrupt input source, active high
J11
TP3
Connector, programming interface for the EBC2 logic CPLD
J12
F/LPCB
Jumper, selects boot code source: open = boot from E²Brain™ module Flash (default);
set = boot from EBC2 LPC Flash
